The Cytac Shotgun Shell Carrier is an easy to install shotshell carrier that holds six 12-gauge shotgun shells for faster reloading and increased ammunition capacity. This side saddle fits Mossberg pump shotguns like the 500, 590, 590DA, etc.
INSTALLATION GUIDE
1. Remove 6 little hex screws from the shotshell carrier to expose two tapped holes in the mounting plate.
2. Lay the shotgun on its side with the election port facing down.
3. Using the supplied big screw with washer, push out the pin located above and to the rear of the trigger guard (leave the screw in the hole).
4. Turn the shotgun over and place the mounting plate on the receiver with the two corresponding holes on the two screws.
5. Starts inserting the screws into the mounting plate and hand tighten (do NOT overtighten). Overtightening may lock up the shotgun's action. To troubleshoot, simply loosen the screws.
- Lightweight,polymer shotshell carrier
- Easy installation,requires no alterations to the shotgun in most cases
- All mounting screws are included,no gunsmithing required
- Holds 6x 12-gauge shotgun shells
All sales at Valken.com are considered final. Valken Sports does not issue cash refunds at any time. Valken Sports provides warranty support and service, as well as paid, out-of-warranty repair service and support for Valken-manufactured products in accordance with all current warranty policies as published by Valken Sports. Valken Sports does not service, repair or provide additional warranty for paintball, airsoft or other products not directly manufactured by Valken Sports and all warranty and service claims for all non-Valken products must be directed to the applicable manufacturer in accordance with their individual warranty and service policies.
